FORD SCORPIO

1985-1994 of release

Repair and operation of the car



Ford Skorpio
- 1.1. Identification of the car
   1.2. Prevention signs
   1.3. Dashboard and combination of devices
   1.4. Control levers on a steering column
   1.5. Keys
   1.6. Doors
   1.7. Blocking of a steering column / lock of ignition
   1.8. Manual transmission
   1.9. Automatic transmission
   1.10. Window regulators with the electric drive
   1.11. Adjustment of provision of a steering wheel
   1.12. Sitting lobbies
   1.13. Illumination of salon
   1.14. External rear-view mirrors with the electric drive
   1.15. Increase in volume of the luggage compartment
   1.16. Screen wipers and washers
   1.17. Raising of the car
   1.18. Towing of the car
   1.19. Start of the engine
   1.20. Start of the cold petrol engine
   1.21. Start of the hot petrol engine
   1.22. Start of the petrol engine with a fuel modulation
   1.23. Start of the diesel engine
   1.24. Features of operation of the car
+ 2. Maintenance
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. Driveshaft and back bridge
+ 9. Steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tires
+ 13. Body
+ 14. Electric equipment


9d8db598

1.9. Automatic transmission

GENERAL INFORMATION

The following provisions of the lever are possible:

P – parking. This situation should be established only at a car stop. Driving wheels are blocked in this situation and interfere with movement of the car. It is necessary to tighten also emergency brake. It is forbidden to install the lever in this situation at the movement of the car;
R – backing. This situation should be established only at the stopped car and the engine idling;
N – neutral situation. This situation should be established at start of the engine and its work idling;
D – advance. Usual situation at the movement. It is possible to pass from situation D into provisions 3, 2 or 1 at the movement of the car;
3 – the movement of the car happens only on the first three transfers;
2 – the movement only on 1 and 2 transfers. It is used at the movement without trailer on roads with rises or descents in mountains or the movement with a speed up to 40 km/h;
1 – the movement only on 1 transfer. It is used at the movement with strong rises and descents.

Start of the engine

To start the engine only at position of the lever in N and P.