FORD SCORPIO

1985-1994 of release

Repair and operation of the car



Ford Skorpio
+ 1.1. Identification of the car
+ 2. Maintenance
- 3. Engines
   + 3.1. OHC engine
   + 3.2. DOHC engine
   + 3.3. V6 engine
   - 3.4. Systems of ignition and engine management
      3.4.1. Technical characteristic
      + 3.4.2. Systems of ignition and engine management
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. Driveshaft and back bridge
+ 9. Steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tires
+ 13. Body
+ 14. Electric equipment


9d8db598

3.4. Systems of ignition and engine management

GENERAL INFORMATION

The system of ignition is intended for ignition of working mix in engine cylinders by the spark category which has to be created at strictly certain moment.

The system of ignition of ESC II is installed on engines with the carburetor and includes the ignition coil, the ignition distributor with the built-in sensor of speed of the engine, an electronic control unit, spark plugs and sensors of temperature of cooling liquid, depression and neutral position of the lever of the selector of the automatic transmission.

The system of ignition of ESC IV is installed on engines with system of injection of fuel and includes the ignition coil, the ignition distributor with the built-in sensor of speed of the engine, the electronic module (controller), spark plugs and sensors of temperature of cooling liquid, neutral position of the lever of the selector of the automatic transmission, the provision of a butterfly valve and absolute pressure.

The V6-24 engine with a working volume of 2,9 dm3 is equipped with system of ignition without ignition distributor.

Safety rules

In order to avoid defeat electric current forbids to touch high-voltage wires at the working engine.

It is strictly forbidden to connect a control lamp or the condenser to the plug of 1 coil of ignition.

To make all connections of measuring devices only at the switched-off ignition.

When checking a compression to remove the central wire from the distributor of ignition and to connect it to the additional candle fixed by the case on weight.

To make carrying out electrowelding works at the switched-off ignition and the switched-off accumulator.