FORD SCORPIO

1985-1994 of release

Repair and operation of the car



Ford Skorpio
+ 1.1. Identification of the car
+ 2. Maintenance
+ 3. Engines
- 4. Cooling system
   4.1. Technical characteristic
   + 4.2. Discharge of liquid and filling of the cooling system
   4.3. Removal and installation of a radiator
   4.4. Removal and installation of the thermostat
   + 4.5. Fan
   4.6. Cooling system pump
   4.7. Temperature sensor
   4.8. Driving belt of the DOHC engine
   4.9. Mechanism of a tension of a driving belt
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. Driveshaft and back bridge
+ 9. Steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tires
+ 13. Body
+ 14. Electric equipment


9d8db598

4.4. Removal and installation of the thermostat

GENERAL INFORMATION

OHC ENGINES

Pump of the cooling system and thermostat of the OHC engine

1 – thermostat case,

2 – laying,

3 – sealing ring,

4 – thermostat,

5 – spring clip,

6 – krylchatka of the pump,

7 – laying,

8 – bearing,

9 – case,

10 – pulley nave

PERFORMANCE ORDER
1. To disconnect a weight wire from the accumulator.
2. To merge the cooling system.
3. To disconnect the top hose from the thermostat case on the forward party of a head of the block of cylinders.
4. To unscrew bolts and to remove the case of the thermostat and laying.
.
5. To pick up the screw-driver a spring clip (the drawing at the left) the thermostat and to take the thermostat together with a sealing ring (the drawing on the right).
6. To clear the interfaced surfaces of the case of the thermostat and a head of the block of cylinders.
7. Installation is made in the sequence of the return to removal, at the same time the arrow (it is shown by an arrow) a stream of the thermostat has to be directed to the engine.
8. To start and warm up the engine, and also to check tightness of connections of the cooling system.
9. After cooling of the engine to check and in case of need to add the level of cooling liquid in a broad tank.

DOHC ENGINES

PERFORMANCE ORDER
1. To disconnect a weight wire from the accumulator.
2. To merge the cooling system.
3. For improvement of access to the thermostat on engines with system of injection of fuel to weaken collars and to pick up the phone connecting the camera of elevated pressure and an inlet collector.
2. To merge the cooling system.
4. To disconnect hoses of cooling liquid from the thermostat case.
5. To switch-off the socket from the switch of the fan of the cooling installed in the thermostat case.
6. To unscrew three bolts and to remove the thermostat case.
7. Installation is made in the sequence of the return to removal, at the same time the safety valve of the thermostat needs to be installed up (it is shown by an arrow).

V6 ENGINES

The thermostat is removed in the course of removal of the water pump.