FORD SCORPIO

1985-1994 of release

Repair and operation of the car



Ford Skorpio
+ 1.1. Identification of the car
+ 2. Maintenance
+ 3. Engines
- 4. Cooling system
   4.1. Technical characteristic
   + 4.2. Discharge of liquid and filling of the cooling system
   4.3. Removal and installation of a radiator
   4.4. Removal and installation of the thermostat
   + 4.5. Fan
   4.6. Cooling system pump
   4.7. Temperature sensor
   4.8. Driving belt of the DOHC engine
   4.9. Mechanism of a tension of a driving belt
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. Driveshaft and back bridge
+ 9. Steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tires
+ 13. Body
+ 14. Electric equipment


9d8db598

4.8. Driving belt of the DOHC engine

GENERAL INFORMATION

Tags of the indicator of a condition of a driving belt

And – an indicator tag,

In – a tag on the lever block

Arrangement of a driving belt on models of cars with the amplifier of steering

1 – pump of the amplifier of steering,

2 – generator,

3 – belt tension mechanism,

4 – water pump,

5 – leading pulley of a bent shaft,

6 – driving belt


Arrangement of a driving belt on models of cars with the amplifier of steering and the conditioner

1 – pump of the amplifier of steering,

2 – generator,

3 – belt tension mechanism,

4 – water pump,

5 – conditioner compressor,

6 – leading pulley of a bent shaft,

7 – driving belt

The driving belt of the water pump puts in action also the pump of the amplifier of steering and the compressor of the conditioner. The tension of a belt is made by the automatic tension device.

Degree of wear of a belt can be determined by the provision of a tag (A) on a fixing bracket in relation to the block (V) on the tension mechanism lever (see rice. Tags of the indicator of a condition of a driving belt). If the belt new, a tag settles down flush with the top part of the block of a natyazhitel. At belt stretching the lever of a natyazhitel of a belt moves and the block on the lever moves up the relation to a mark in a bracket. Upon transition of a mark to the lower part of the block of a natyazhitel the belt is subject to replacement.

Removal and installation

PERFORMANCE ORDER
1. For removal of a belt to turn clockwise the lever of a natyazhitel a face key (17 mm) for inflow in the center of a pulley, to take off a belt from pulleys and to slowly release the tension mechanism.
2. At installation of a belt to take away the tension mechanism in the same way, as well as at removal, and after installation of a belt on pulleys slowly to release the tension mechanism. At the same time there will be automatic belt tension.